50
10 Basic Tasks
10.1 Opening & Closing the Doors
The main door and filament door on your F410 have high-friction hinges to help the doors stay open on
their own.
When opening the doors, take care not to open them too far, as this can cause them to fall backwards.
Likewise, make sure they are open far enough they will not fall back into the closed position. The image
below shows roughly the recommended range of angles for opening both doors.
When closing the doors, keep your hand on the door all the way to the closed position. Don’t let it go
and let it fall closed.
10.2 Running a Print Job
Preparing for and running a print job can be thought of as 2 separate workflows: one for the physical
side where you set up the printer, and one for the software side where you prepare your 3D model for
printing. We’ll cover them both here.
To Next Page
Loading...
