Fusion3 F410 - Preparing the Print Bed

71
If you’re immediately starting another print, make sure the bed is dry before applying fresh gluestick.
10.9 Preparing the Print Bed
Use the gluesticks included with your toolkit to apply one or more even layers of glue (depending on
your material) to the bed.
 The glue layer does not have to be thick; you do not have to push down on the gluestick as you
apply it.
 You do not need to cover the entire bed if you’re printing a small part.
 Remember to avoid putting gluestick over the corner foil unless you know your part will overlap
those areas.
 Apply fresh glue to a clean bed for every print!