7
Thanks to its full enclosure, the F410 is fairly insensitive to air drafts, dust, etc. It’s still better to avoid
environments with these characteristics if possible.
3.5 Power
Your F410’s peak power draw is approximately 6 amps at 110VAC. Operating draw will depend on the
material being printed; higher temperature materials require more power.
Please use the included power cord to connect your F410 to a 3 prong outlet. Due to the high power
draw, please be mindful that you do not overload any power strips/surge protectors you use.
If you are installing multiple F410s, be mindful of the capacity of your electrical circuits. Three F410s
can over-draw a 15A circuit.
NOTE FOR INTERNATIONAL CUSTOMERS: You will need to check the internal power supply’s voltage
select switch BEFORE operating your F410. Please contact Fusion3 Customer Support at
support@fusion3design.com or 1-877-452-0010 x2 for more information.
3.6 Network
Your F410 contains a 10/100 Ethernet port to allow you to connect the printer to your local network. It
will set up a web page that allows you to remotely monitor and control the printer.
This is an optional feature; the attached LCD also gives you full control over your printer.
By default this web page is only accessible inside your local network. It is NOT accessible from
the wider internet (it is not cloud-based)
See section 6 for more information.
3.6.1 What if I need Wifi?
You can purchase an Ethernet to wifi bridge and use that to get your F410 onto your wireless network.
We have tested the following and verified they work:
http://www.amazon.com/IOGEAR-Universal-Ethernet-Adapter-GWU627/dp/B004UAKCS6
http://www.amazon.com/TP-LINK-TL-WA801ND-Wireless-300Mbps-Repeater/dp/B004UBU8IE
For more information on using, changing, and troubleshooting the network interface, please see section
6.
3.7 Setting up Simplify3D
Please see our separate Simplify3D setup guide. It’s available:
As a PDF on your SD card
On our website at
https://fusion3design.com/manuals/
To Next Page
Loading...
