FUTABA T16IZ SUPER

120
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Telemetry:SBS-01MLforPixhawk®
7KH6%60/GLVSOD\VWHOHPHWU\GDWDIURPWKHGURQHÀLJKWFRQWUROOHU3L[KDZN
◆ RegisterSBS-01MLtotransmitterbymethod1or2.
ConnecttheSBS-01MLtotheS.I/F
connectoronthebackofthetransmitter.
◆ Linkagemenu → Sensor → 3/3
◆ Linkagemenu → Sensor
１. Registrationtotransmitter
2. Manualregistrationmethod
TELEMPort
S.BUS2Receiver
S.BUS2Port
S.BUSPort
S.BUSPort
Futaba
T16IZSUPER
Pixhawk
Tap8or16todisplaya
listofsensorsthatcanbe
registered.TapSBS-01ML
toregister.
● Callpage3of[Sensor].
*Pleasenotethattheproperdefaultslotforthisaccessoryisnumber16(8-16).
Thissensoruseseightslots.Beingmadetoastartslotare8and16.
ConnecttheSBS-01MLto
thetransmitterasshown,
thentapRegister.
Registrationiscompletewhen
thisscreenappears
Completeregistrationandremove
SBS-01MLfromthetransmitter.
ThedefaultslotforSBS-01MLis#16.
Whenusing#8,changetheSBS-01ML
slotaccordingtotheprocedureon
page98.