FUTABA T16IZ SUPER

142
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Elevator
→
Camber
Elevator
→
Camber
Elevator
→
Camber
Elevator → Camber
[Corresponding model type]: Airplane/glider, 2 ailerons or more
7KLVIXQFWLRQLVXVHGZKHQ\RXZDQWWRPL[WKH
FDPEHUÀDSVZLWKHOHYDWRURSHUDWLRQ:KHQXVHG
WKHÀDSVDUHORZHUHGE\XSHOHYDWRUDQGOLIWFDQ
be increased.
Note: Tailless wing elevator can be operated
when this mix is activated.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWKH>@LWHPRI
the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJ
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set.
The VR operation mode can also be
selected.
ŏ$PL[LQJFXUYHFDQDOVREHVHW
(For a description of the curve setting
method, see the description at the back of
this manual.)
ŏ6HOHFW>(OHYDWRUń&DPEHU@DWWKHPRGHO
menu and call the setup screen shown
below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Aileronsandflapsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
FinetuningVRsetting
Operationmode
Adjustmentrate
Activatethefunctionby
tappingthe[INH].
ŏ5HWXUQWR0RGHOPHQX
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.