FUTABA T16IZ SUPER

143
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Ailerons,flaps
andelevatorsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Activatethefunctionby
tappingthe[INH].
Cambermixing
[Corresponding model type]: Airplane/glider, 2 ailerons or more
7KLVIXQFWLRQDGMXVWVWKHUDWHRIFDPEHU
RSHUDWLRQZKLFKRSHUDWHVWKHZLQJFDPEHU
DLOHURQVFDPEHUIODSVEUDNHIODSVLQWKH
QHJDWLYHDQGSRVLWLYHGLUHFWLRQV7KHDLOHURQ
IODSDQGHOHYDWRUUDWHVFDQDOVREHDGMXVWHG
LQGHSHQGHQWO\E\FXUYHDQGDWWLWXGHFKDQJHV
caused by camber operation can be corrected.
,QLWLDOVHWWLQJDVVLJQVFDPEHURSHUDWLRQWRVLGHOHYHU/6
ŏ7KHXSGRZQVLGHUDWHVRIWKHDLOHURQÁDSDQG
elevator servos can be adjusted by curve. When
the mixing direction is reversed by the linkage,
adjustments can be made by changing the
mixing rate polarity (+ or -).
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ$GHOD\FDQEHVHWIRUHDFKFRQGLWLRQ$FXW
switch which can turn OFF the delay function can
be set.
ŏ7KHVSHHGRIWKHDLOHURQÁDSDQGHOHYDWRUVHUYRV
can be set. (In side/Out side)
Servospeedsetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
ŏ6HOHFW>&DPEHUPL[LQJ@DWWKHPRGHO
menu and call the setup screen
shown below.
Conditiondelaycut
switch
Conditiondelaysetting
ŏ5HWXUQWR0RGHOPHQX