FUTABA T16IZ SUPER

181
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Throttlecurve/ThrottleHovertrim
ŷƋƕƒƗƗƏƈŃŃƆƘƕƙƈ
7KLVIXQFWLRQDGMXVWVWKHWKURWWOHRSHUDWLRQFXUYH
for each condition for optimum engine speed to
throttle stick movement.
8SWRFXUYHSRLQWVFDQEHVHWIRUWKHSRLQW
FXUYHW\SH+RZHYHUZKHQWKHSRLQWVDQGRWKHU
SRLQWGDWDLVXVHGDVLPSOHFXUYHFDQEHHDVLO\
created by reducing the number of input points of
WKHFXUYHWRDQGHQWHULQJWKHVSHFLILHGYDOXHDW
the corresponding points.
űƒƕƐƄƏŃƆƘƕƙƈŃƄƇƍƘƖƗƐƈƑƗ
ŏ1RUPDOFXUYHFUHDWHVDEDVLFFXUYH
centered around hovering. Use it along
with the normal pitch curve and adjust so
that up/down control at a constant engine
speed is easiest.
ŬƇƏƈŃƘƓŃƆƘƕƙƈŃƄƇƍƘƖƗƐƈƑƗ
ŏ6HWDQLGOHXSFXUYHWKDWPDLQWDLQVD
constant speed at all times, even during
operation which reduces the pitch
SHUIRUPHGLQÁLJKW&UHDWHDFXUYHPDWFKHG
to loop, roll, 3D, or other purposes and the
idle up curve according to the performance.
ŲƓƈƕƄƗƌƒƑŃƓƕƈƆƄƘƗƌƒƑƖ
WARNING
Whenactuallystartingtheengineand
flying,alwayssettheidleupcondition
switchtoOFFandstarttheenginein
theidlingmode.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ*URXSVLQJOHLWHP:KHQ\RXZDQWWR
simultaneously enter the same settings to
other functions, make the settings in the
group mode. In this case, the same setting
contents are entered to the all conditions.
When you want to set each condition
independently, make the settings after
selecting the single mode (Initial setting).
ŏ6HOHFW>7KURWWOHFXUYH@DWWKHPRGHO
menu and call the setup screen shown
below.
Pointcurvetypeis9
points(initial),butfor
simpleuse,4~5points
aresufficient.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethebackofthis
manual.
Currentlyselectedconditionname
Throttlehovertrim
operatingposition
(Whiteline)
ŏ5HWXUQWR0RGHOPHQX