FUTABA T16IZ SUPER

187
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Pitch → Needle
7KLVPL[LQJLVXVHGZKHQWKHHQJLQHLVHTXLSSHG
ZLWKQHHGOHFRQWURORURWKHUIXHODLUPL[WXUH
DGMXVWPHQW$QHHGOHFXUYHFDQEHVHW
$QDFFHOHUDWLRQIXQFWLRQZKLFKWHPSRUDULO\
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@21LV
displayed.)
ŏ:KHQ\RXZDQWWRVHWWKHVDPHFRQWHQWVDW
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
ŏ $QHHGOHFXUYHFDQEHVHW
ŏ $VZLWFKFDQEHVHW
When [--] is set, the mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap
to the [--] item. Tap the screen to call the
selection screen and set the switch and its
ON position.
< Acceleration function setting>
ŏ$FFHOHUDWLRQFDQEHVHWDWERWK
acceleration (high) and deceleration (low).
ŏ7KHDFFHOHUDWLRQUDWHUDWHDQGWKHUHWXUQ
time after operation (damping) can be set.
ŏ$QRSHUDWLRQSRLQW$FWSRVLWLRQDW
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
ŏ6HOHFW>3LWFKń1HHGOH@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
increases needle operation at throttle stick
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
DGMXVWHG
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Normally,use[Point]type.
ŏ5HWXUQWR0RGHOPHQX