135
<Model Menu (Airplane/Glider Functions)>
58'(/(
0RGHO
&RQGLWLRQ
6QDS5ROO
2))
6ZLWFK
2))
2))
2))
2))
$&7
2))
2))
2))
5LJKW83
5LJKW'RZQ
/HIW83
/HIW'RZQ
$,/
5DWH
*URXS
*U
21
6DIHW\6:
0DVWHU
0RGH
2))
0DVWHU6:
0RGHO
&RQGLWLRQ
6QDS5ROO
5LJKW83
5LJKW'RZQ
/HIW83
/HIW'RZQ
$,/
(/( 58'
,1 2XW
,1 2XW
,1 2XW
6SHHG
Snap Roll
This function selects the switch and
rate adjustment of each rudder, (ailerons,
elevators, or flaps) when a snap roll is
performed.
up, right/down, left/up, left/down)
state in which the direction switch was
switched to the direction in which you
selected, snap roll in each direction can
switches.
set so that snap roll is not executed
when, for instance, the landing gear
is lowered, even if the switch is turned
on accidentally. The snap roll switch is
activated only when the safety switch is
side) (Page 2/2)
*The snap roll up side left and right and down side left and right direction switches
are selected here.
The operation speed of each control surface when
performed.
(Single/Fine tuning/All Cond.)
(For more information, see the description at the back
of this manual.)
AIL1
AIL2
ELEVATOR
ELEVATOR 2
RUDDER
(at AILEVATOR)