91
<Linkage Menu>
7LPHU
0RGHO
7LPHU
0RGH
6WDUW6WRS6:
6SOLW7LPH6:
0HPRU\
8S
؟
2))
2))
2))
2))
5HVHW
2))
ڂ
7LPHU
0RGH
6WDUW6WRS6:
6SOLW7LPH6:
0HPRU\
8S
؟
2))
2))
2))
2))
5HVHW
2))
ڂ
0RGHO
6SOLW7LPH
5HWXUQ
&OHDU
7LPHU
/DS6SOLW7LPH
/DS6SOLW7LPH
/DS6SOLW7LPH
/DS6SOLW7LPH
Timer
The Timer function may be set for any desired
time, i.e. engine run time, specified times for
competitions, etc. Two independent timers are
provided for your use. The timers are stored
independently with each model, meaning that
when you switch between model setups, the timer
associated with the new model is brought up
automatically.
The timers may be set to start and stop from
the motion of any switch or stick. You may set the
ON and OFF directions freely. Each timer has a
capacity of up to 59 minutes 59 seconds.
Up timer/Down timer/Hour selection
Start/SWtop switch setting
Lap time switch selection
Each timer may be set for count-down or count
up operation with your choice of a target time. Also
Split Time may be set up and counted.
If a target time is set and the timer reaches
this point, a buzzer will sound for each count is
generated.
Countdown timers sound one short beep during
the last twenty seconds and two short beeps during
the last ten seconds before reaching the target, then
a long tone at the target time, and continue counting
with displaying a minus (-) sign. Count-up timers
also beep the last twenty and ten seconds, beep the
target time, and keep counting upwards until shut
down.
Timer operation
Hour mode
<Lap time list>
To Next Page
Loading...
Need help?
General
