80
<Linkage Menu>
Function
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, on the function-
setting screen of the linkage menu, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and input
controllers (sticks, switches, trim levers and trim
switches). You can also assign the same function to
multiple servo output channels such as assigning
elevator function to CH2 and CH3.
Function change
*Multiple channels can be assigned to 1 function.
*Multiprop1,2 is an optional object for Multiprop decoders.
<CH which can be Multiprop set up.>
FASSTest 18CH---1-12CH
FASSTest 12CH---not set
S-FHSS ---not set
DG1, DG2 (switch channels)
Off) channels. You can freely change combinations
between servo output channels and input controllers
(sticks, switches, trim levers and trim switches).
Channel restrictions by a System Type
FASSTest 18CH---16 CH+2 Switch
S-FHSS --- 8 CH
Operation control change
*The same control can be assigned to multiple channels.