EasyManuals Logo

FUTABA T18MZ User Manual

FUTABA T18MZ
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
107
<Model Menu (Common Functions)>


call the setup screen shown below.



Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also be

that the motion of a command channel, called the
"master," is added to the motion of the mixed channel,
called "slave."
You may choose to have the Masters trim added
to the Slave channel response, if you desire ("Trim"
setting). The mixing curve can be changed so that the
undesired tendencies can be corrected effectively by
setting the LINEAR1/LINEAR2/EXP1/EXP2/VTR/
LINE/SPLINE modes. The Delay function can be
programmed for each rate. The Delay is used to change
the rate smoothly when switching. You may define
Mixing ON/OFF switch, control or you may choose to
have mixing remaining on all the time.
Offset-type mixing applies a fixed offset or preset
to the programmed channel servo operation and may
control up to four circuits simultaneously.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with other
programmable mixing functions. The link function can
be set up for Master and Slave channel individually.
The slave channel AFR mode (STK-STK mode)
may be selected, where the slave channel AFR and
D/R settings are observed when Link function is set.

circuit. (Fine tune function)

After this function is activated, the
master and slave function names (or
offset mixing) are displayed.


(For more information, see the description at the back of this manual.)




(Timer mode)
(Normal mode )

The on time (start/stop time) can be set up to
9 seconds. It is useful for landing gear control of
the jet or scale plane, etc.

mixing)

Table of Contents

Other manuals for FUTABA T18MZ

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA T18MZ and is the answer not in the manual?

FUTABA T18MZ Specifications

General IconGeneral
BrandFUTABA
ModelT18MZ
CategoryRemote Control
LanguageEnglish

Related product manuals