151
<Model Menu (Helicopter Functions)>
18//
$&7
2))
6ZLWFK
5DWH
0RGHO
*RYHUQRU
5DWH &75/ 5DWH *URXS
0RGH
USP
USP
USP
1RUPDO
5DWH
5DWH
)LQH7XQLQJ
18//2))
2))
,1+
,1+
,1+ 18//
*U
*U
*U
6HW*29
Governor Mixing
This is used to switch the RPM of the helicopters
head. Up to 3 rates can be set for each condition.
*The governor is used by connecting the governor speed
setting channel to governor function.
*When using an independent governor [ON]/[OFF] switch,
connect the AUX([ON]/[OFF]) connector of the governor to
Governor2 and set the switch to Governor2 at the Function
menu of the Linkage Menu.
Setting method
When you want to set the same settings to other
conditions, select the group mode (Gr.). When
you want to add settings to the selected condition
only, select the single mode (Sngl).
*When using the Fuel Mixture function, the mixture servo is
controlled from the governor. When transmitting the mixture
curve data from the transmitter to the governor, the governor
AUX (m.trm) connector must be connected to Governor2
function and governor side setting performed. See the
governor instruction manual.
*VR selection, adjustment width, and adjustment direction
can be set.
To Next Page
Loading...
Need help?
General
