FUTABA T18MZ - Swash (Helicopter Only)

89
<Linkage Menu>

0RGHO
0L[LQJ5DWH
6ZDVK'HWDLO 6ZDVK$)5
3,7WR(/(
$,/WR3,7
(/(WR$,/
(/(WR3,7
 
 
 
 
 
3,7WR$,/
0L[LQJ
/LQNDJH&RPSHQVDWLRQ
)XQFWLRQ'LU
$LOHURQ
(OHYDWRU
6SHHG&RPSHQVDWLRQ
 
 

/RZ3LWFK






0RGHO
1HXWUDO3RLQW 6ZDVK$)5
$LOHURQ
(OHYDWRU
+



/
/RZ3LWFK

(QWHU
3LWFK
6ZDVK 6ZDVK'HWDLO
+LJK3LWFK





Swash


Neutral Point
On your linkages, if the servo horn deviates from
perpendicular at neutral, the linkage compensation
functions may not work effectively. This neutral
point setting reads the linkage compensation neutral
position. However, this adjustment only changes
the reference point of the compensation function
on the swash details screen and does not affect the
neutral position of other functions.

point.
Swash AFR


elevator, and pitch functions.
Mixing Rate
(Normally, the default value is used.)

to the swash plate so that it moves in the correct
direction for aileron, elevator, and pitch operation.



that the swash plate moves in the correct direction
Linkage Compensation

interference when the ailerons or elevators are
operated when the throttle stick was in the low or
high position.
Speed Compensation
This speed compensation function make
adjustments for interference when the travel of
each servo is different due to swash plate operation.
For HR-3, it compensates the speed by dropping
the operating speed of the aileron and pitch servos
during elevator operation.

