19
<Before Use>
*This transmitter has two ratchet plates, one for airplane and
the other one for helicopter. If you tighten both screws, you
*If you want to change the setting from airplane to helicopter
(or from helicopter to airplane), turn the ratchet screw
clockwise until the throttle stick moves freely. Then turn the
screw for the helicopter until you get the tension you like.
Battery exchange
Note: Detaching the battery while the power
is one can cause data you have recently edited to
be lost.
*In the Mode 1/3, arrangement of a screw is opposite.
To Next Page
Loading...
