86
<Linkage Menu>
Throttle Cut
Throttle cut provides an easy way to stop the
at idle. The action is not functional at high throttle
to avoid accidental dead sticks. The switch’s
location and direction must be chosen, as it defaults
Throttle cut setting procedure
*With throttle stick at idle, adjust the rate until the engine
consistently shuts off, but throttle linkage is not binding.
Note: When conditions are set, at Throttle cut setup can
be performed for each condition. Throttle cut can only be
up this function within the condition. When using throttle
to another condition, throttle cut is canceled and no longer
does not have throttle cut active.
To Next Page
Loading...
