FUTABA T18MZ - Servo Monitor

70
<Linkage Menu>
Servo Monitor

This is used for testing servo movement. Touch
“Moving Test” (repetition mode) or “Neutral

one shows on the screen. To get from one to the
other, simply touch the field again, and you will



move from “Moving Test” to “Neutral Test”

to start testing your servos. The “Neutral test” is
good for finding the neutral position of a servo
horn.
Servo test operation








WARNING
Don't set a servo test mode when the drive motor
is connected and the engine was started.
■
Inadvertent rotation of the motor or acceleration of the engine is
