To Next Page

To Previous Page

Toolbox









A special toolbox is included with your T18MZ.

This allows you to make off of the mechanical



Hexagonal wrench (1.5mm and 2.5mm)



replacement of the switches.

Tool for removing switch nuts.

This is used when changing or replacing

switches.

Stylus pen

A rubber cap is attached to the stylus pen/



when operating the touch panel. The stylus allows



damaging the panels surface.





Servo(Option)

・

Toolbox

Servo(Option)

Purchase servos appropriate for their intended use.

*Analog servos may not be used when operating in the

FASSTest 12CH mode.

When operating in the FASSTest12Ch mode use digital servos,

this includes all brushless and S.Bus servos.

FUTABA T18MZ User Manual

Other manuals for FUTABA T18MZ