78
<Linkage Menu>
WARNING
Do not perform the linking operation when the
drive motor is connected and the engine was
started.
■
Inadvertent rotation of the motor or acceleration of the engine
Once the link operation is complete, please check
that your receiver can be operated with the linked
transmitter.
Check operation sufficiently before flying after
linking.
■
If the same receiver is sending in the vicinity, there is the danger
that the transmitter may be linked with that receiver.
CAUTIONS
Always turn on the transmitter power after linking
is complete.
When pairing with the transmitter, be sure that a
previously linked transmitter is not transmitting
Linking method (T18MZ
↔
R7008SB)
*Do not perform the linking operation when the drive motor is
connected or the engine is running.
* When you use two receivers, please be sure to setup a
"primary" and "secondary" in the "dual" mode.
*Since two sets of receivers cannot be individually recognized
without using a "primary" and "secondary" setup, it is
impossible to receive telemetry data correctly.
* You must link one receiver at a time. If both power supplies
to the receivers are switched on simultaneously, data is
received incorrectly by the transmitter.
* If a dual receiver function is used, in order to receive sensor
information correctly by both sets, telemetry data will be
slower compared to a single receiver setup.
* You cannot link three sets of receivers.
To Next Page
Loading...
