Futurecom VR - Page 82

8G093X01 R5
VR Programming Guide
August 2022 Page 82 of 144
Field Name
Range
Description
Notes
3. ‘Console
Ack’
3. VR proxies
Emergency Alert
through the MSU to
the site and
requests
acknowledgement
from the console
that it has been
received.
3. Typically used when DVRS is deployed in a
trunking setup. Requires:
• Emergency Setup→VR Emergency Echo
Ack to be checked.
• PSU CPS: Emergency
Config.→Conventional Emergency Profile
→Console Ack Required (DVRS) to be
enabled.
When enabled, DVRS will proxy both FNE and
Console acknowledgements to the PSU.
When disabled, the DVRS will only proxy the
Console acknowledgement to the PSU.
If enabled the DVR will proxy the FNE Ack first to
the PSU to prevent further emergency retries
while the console ack is being processed. If
disabled, the PSU will continue emergency
retries until it receives the console ack.
Should be disabled when generic PSUs are in
use because they are unable to differentiate
between FNE and Console
acknowledgements.
4. ‘Uncond.
VR Ack’
4. VR acknowledges
Alert from a PSU
regardless of
MSU’s ability to
proxy this alert to
the FNE.
4. Typically used on system analog conventional
channels when MSU is unable to transmit
emergency signaling (e.g.: non-ASTRO
signaling type set to ‘None’).
PTT ID
Check box
(checked)
Enables or Disables
the pass through of the
PSU PTT ID through
the VR.
If disabled, the MSU ID
will be sent instead.
When MSU channel type is analog or Type II, this
field applies only to:
• Analog PSU using Analog or Mixed VR
channels
• Enhanced PSU using Mixed or Forced Analog
VR channels.
Exceptions when enabled:
• Analog Conventional System: MSU ID sent
when local PSU ID size exceeds limit
• Type II Trunking System: MSU ID sent for calls
(PTT/Emer PTT); Local PSU ID sent only for
Emer Alert; MSU ID sent when local PSU ID
size exceeds limit
• See notes in Analog Setup → MDC PTT ID
Offset