Page 3-24 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 4 190-00716-01
3.10 Non-Garmin TAS/TCAS I Traffic System Option Configuration
Follow this procedure to enable a non-Garmin TAS/TCAS I traffic system function for the G1000 system
if required.
NOTE
The G1000 can only be configured for TIS or
TAS/TCAS I, but not both. Performing this
procedure will automatically disable the TIS function. Coordinate this configuration with
section 7.13 “Non-Garmin Traffic System (TAS/TCAS I) Functional Check”.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “System
Upload” page on PFD1 using the small FMS knob.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Airframe Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - Traffic System Option”. Press ENT key on
PFD1.
4. Verify the “King Air - Traffic System Option” is displayed in the “Item” window. Press
“LOAD” softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.
To Next Page
Loading...
Need help?
General
