Garmin GPSMAP 396 - Using the Weather Tab; Weather Explorer Tab with Storm Cells

GPSMAP 396 Owner’s Manual 123
MAIn Menu > setuP tAb
The Status eld shows one of the following:
Tuning
—the unit is attempting to tune to the specied
frequency and bit rate.
Scanning—the unit is automatically scanning through the
frequencies and bit rates.
Receiving
—the unit is receiving DGPS signal and ready for
operation.
Check Wiring—the unit is not making connection with
DGPS receiver.
To restart the scan:
1. Press MENU.
2. Highlight Restart Scan, and press ENTER.
•
•
•
•
To manually enter a frequency and bit rate:
1. With the unit set to GARMIN DGPS or RTCM In/NMEA Out,
use the ROCKER to highlight the Beacon eld, and press
ENTER.
2. Highlight User, and press ENTER.
3. Highlight the Frequency or Bit Rate eld, press ENTER, and
enter a frequency or bit rate. Press ENTER when done.
When the unit is receiving a DGPS signal, the SNR (Signal to Noise
Ratio) and Distance elds show data. The SNR range is 0 dB to 30
dB, with 30 being the best. The Distance may or may not show data,
based on the signal being broadcast from the DGPS site.
The DGPS beacon transmitters are operated by the United States
Coast Guard (or similar government agency in other countries),
which is responsible for their accuracy and maintenance. For DGPS
transmitter problems or to nd the most updated list of frequencies
and coverage areas, contact your local USCG or see their Web site at
www.uscg.mil.