172 GPSMAP 396 Owner’s Manual
APPendIX > MessAges
Transducer Disconnected, Sonar Turned Off—the unit has no transducer
attached, has a bad cable/transducer, or has a disconnected transducer
cable.
Transfer Complete—data transfer was completed.
USB Connected—the USB cable was recently plugged in.
User Timer Expired—the Timer Alarm value has counted down to zero.
VNAV Cancelled—VNAV function has been cancelled due to a change in
the active route.
Water Speed Sensor is Not Working—the speed sensor is not detected.
Check the connections.
Water Temperature Alarm—sonar has reported a temperature above,
below, inside, or outside the specied values(s).
Waypoint Already Exists—a waypoint with the same name already exists.
Waypoint Memory Full—the unit has stored the maximum number of
waypoints.
XM Antenna Not Responding—the unit is unable to communicate with
the GXM 30/30A.
XM Connected—the GXM 30/30A antenna was recently plugged in.
To Next Page
Loading...
