This section will configure the network stream parameters
IP Address of streaming source
Port of the streaming source related to the IP address
The interface connection of the SX-3000 will receive the network stream
Video and Audio PID are usually provided by the broadcaster. If the video or audio PID is set to
‘0’, the SX-3000 will automatically search and play back the last video or audio stream found in
the network system.
Check Force PID box to ensure the SX-3000 to use the provided PIDs. Note: having the values
set to ‘0’ will cause errors in receiving the network stream when the Force PID box is checked.
Choose between MPEG2 and H.264 (MPEG4) or Auto-Detect.
Select whether to apply 3D demux to incoming video stream. None (2d): 2D video output; Side-
by-side (3D): 3D video output with side-by-side 3D demux
Audio Type can be automatically detected, or you may choose either AC3 or MPEG2,
depending on the exact audio format delivered by streaming content
AC3 audio output from SX-3000 will pass-through as a digitally compressed audio system to an
external audio processor. Select a pair of SX-3000 audio output channels to send this pass-
through compressed audio system
Setting the “PTS sync” configuration option will force playback to use the Presentation
TimeStamp (PTS) header in the IP stream to synchronize audio and video playback.
(Recommended: unchecked)
Note: Selecting this option will use a new mechanism to sync audio and video playback. Check
this option only if the default, unchecked option fails to achieve proper audio and video sync.
To Next Page
Loading...
