GDC SX-3000 - Page 20

2. SMS
- 20 -
April 20, 2015
SX-3000 Standalone Integrated Media Block™ with
Portable Storage/ Enterprise Storage User Manual
1
[Use startup / shutdown
password]
There are 3 levels of users on the system
- User, Technician, and
Maintenance. If this option is checked, the system will start up with a
password dialog and the user will have to authenticate themselves as
one of the above 3 users to start using or shut down the system.
2
[Playlist menu password
protected]
If this option is checked, the User level will be denied the ability to edit
or create any playlists. Only Maintenance and Technician level users
will be able to create and edit playlists.
3
[Skip non-playable
composition playlist]
With this option checked any non-playable CPL within a Show playlist
will simply be skipped, a message will appear on the SMS screen
indicating that a CPL has been missed, however playback will continue.
4
[Reset TimeCode at end of clip]
If the ‘
Reset TimeCode at end of clip’ option is selected, the timecode
will reset to zero [0:0:0:0] whenever a playback ends or stops. The
Timecode Display will reset to zero [0:0:0:0] while the Duration and
Remaining time will reset to 00 hr 00 min 00 sec. The Slider Bar will
return to its starting point at the extreme left.
If the ‘
Reset TimeCode at end of clip’ option is not selected, the
system will retain the timecode at the point in which playback ends
or stops. The Slider Bar will remain at where the playback ends or
stops.
5
[Skip checking assets
during ingest]
With this option checked the Digital Cinema Package assets will not be
checked for their integrity, this option will reduce ingestion time but
decrease the reliability of the ingestion.
6
[Subtitle Overlay]
[Subtitle Overlay] option. For more information, please refer to Section
2.8.2. Subtitle Overlay .
7
[Subtitle Delay]
This option provides the ability to delay the on screen subtitles, the delay
is set in number of frames.
8
[Font Size]
‘
Font Size’ option. For changing the size of the font on the screen.
9
[ASI Packet]
This option is provided to select the size of the packets (204 or 188
bytes) on the incoming ASI signal.
10
[Date Format]
‘
Date Format’ option. For changing the displayed format of the
date.
11
[Language]
‘
Language’ option. For changing the user interface language.
12
[Change User Password]
[Change User Password] button. For changing t h e User Password.
When [Change User Password] is pressed, 3 prompts will appear. The
first prompt is for the user to enter the old password, the second
prompt is for the user to enter the new password, and the third prompt
is for the system to verify the new password.