IP Address: Unique IP address assigned to the server you are configuring.
Port Number: Port number assigned to the query server.
Time out: The time in seconds that the Workstation waits for a response from the server before timing out.
Information Model: There are two items of Information Model:
Study Root - Starts queries at the study level;
Patient Root - Starts queries at the patient level.
4. Select the “Verify” button to verify that the server is connected. A verified successful message appears if
the server has connected. Select “OK” to close the screen.
5. Repeat steps one through four for each Query & Retrieve server on the network. You can edit or delete
server by clicking the relevant button.
6. When you have finished configuring all servers, select the “Exit” button to close the Query & Retrieve
Screen.
Setup DICOM MPPS Server
To configure the MPPS server:
1. Select “MPPS Servers” button from the Workstation setup screen.
To Next Page
Loading...
