GE MEDICAL SYSTEMS
D
IRECTION 2300000, REVISION 2 LOGIQ™5 SERVICE MANUAL
Chapter 8 Replacement Procedures 8-43
8-5-3 Rear Cover
Purpose: This is a description on how to remove and replace the Rear Cover.
8-5-3-1 Tools
• Common pillips screwdrivers
8-5-3-2 Needed Manpower
• 1 persons, 15 minutes + travel
8-5-3-3 Preparations
• Shut Down the System and switch off the Main Breaker at the rear as described in section 4-3-2 on
page 3.
8-5-3-4 Removal Procedure
1.) Remove the Left Cover. Refer to section 8-5-1 on page 39.
2.) Remove the Right Cover. Refer to section 8-5-2 on page 41.
3.) Unscrew six screws (1-6).
4.) Remove the Rear Cover. Refer to Figure 8-50.
Figure 8-50 Removing the rear cover
6
66
1
2
3
4
5
6
To Next Page
Loading...
