GE MEDICAL SYSTEMS
DIRECTION 2300000, REVISION 2 LOGIQ™5 SERVICE MANUAL
4-16 Section 4-3 - General Procedure
4-3-11 Backup and Restore Database, Preset Configurations and Images
4-3-11-1 Formatting Media
1.) To format the backup media, CD-ROM or MOD, select the UTILITY
tab on the Touch Panel.
2.) Select CONNECTIVITY
, then TOOLS( in case of BT05 SW, REMOVABLE MEDIA ). Properly label
and Insert the backup media.
3.) Select the media type from the drop down menu.
4.) Enter the label for the media as shown in Figure 4-10. It is best to use all capital letters with no
spaces or punctuation marks.
5.) The Ultrasound system displays a pop-up menu, as shown in Figure 4-11. When the formatting has
been completed, press OK
to continue.
6.) If desired, verify that the format was successful by returning to Utility>Connectivity>Tools (in case
of BT05 SW, Removable Media) and selecting VERIFY
as shown in Figure 4-10.
NOTICE
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
unlocked and the MOD susceptible to damage if moved. If forced to use this method, reboot the
system, then insert and eject a known good disk using one of the other manual ejection
methods.
Figure 4-10 Format and Verify Media
Figure 4-11 Format Successful Pop-up Menu
Verify Format
Format
Media
Selection
Media Label
To Next Page
Loading...
Need help?
General
