GE PACSystems RX3i - Page 63

`
show node
GFK-2572 Chapter 2 Monitor Level Commands 2-47
2
Node Status Definitions
Field
Value
Definition
Module
Status
OK
Module is operating correctly.
NOT OK
Module has encountered a fatal error.
Config
source
Programmer
All configuration items for the module were delivered via
the Programmer.
Other
Some or all configuration items for the module were
delivered via means other than the Programmer. (e.g. via
Command Line Interface commands). Use “show config”
to see source for specific configuration items.
Restart
Reason
Power Cycle
Power-cycle cause the last reset of the module.
Reset Button
A push of the reset button caused the last reset of the
module.
Command Line Interface
Execution of the Command Line Interface command
restart caused the last reset of the module.
Fatal Error
A fatal error detected by the module caused the last reset
of the module.
Firmware Update
An update for the module’s firmware caused the last
reset of the module.
Go To Boot Firmware
Update
Start of firmware update caused the last reset of the
module.
Over Temperature
Module detected an over temperature condition and
caused the last reset of the module.
Hardware Watchdog
Trip
Unexpected hardware watchdog expiration caused the
last reset of the module.
Module Restart –
Unknown Reason
Cause of the last reset of the module is not known.