om 5184516-100 Rev. 5 6-17
ILLUSTRATION 6-12
IMAGE STACKING PROCESSING BUTTONS
Add Single Image to Stack List:
When selected, this button adds the current image to the
Stack list. The currently displayed image type must match
the Stack type (assuming the currently displayed image is
not already in the stack list).
Remove Single Image From Stack List:
When selected, this button removes the current image from
the Stack list. This button is only available when the current
image has already been added to the Stacking list, and
before the stacked image has been saved to disk.
Stacking Buttons –
When selected, any one of the Stacking buttons enables the
stacking process. These buttons become available once an
image has been added to the Stacking list.
There is no limit on the number of images that can be used
to create a Max or Min Opac image.
When you select the Average button a Multi–frame Mask
image is created. A maximum of 64 images can be included
in the Multi–frame stacked image.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
