om 5184516-100 Rev. 5 6-22
ILLUSTRATION 6-16
CURSOR FOR IMAGE SELECTION
SECTION 16
DELETE IMAGE
Delete images during acquisition:
1. Display images and select DELETE from the Image Display Monitor. A “D” will
be displayed in the lower right corner.
To delete a single image stored on the PC hard drive follow the instructions given
below:
1. When the undesirable image is displayed on the Image Monitor select the
DELETE button in the lower right corner of the Image Screen.
2. A “D” will be displayed in the lower right corner of the image.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
