2026265-075C Solar 8000M/i patient monitor 5-29
Troubleshooting: Get error logs
Change the PC’s IP address
Windows XP Windows 2000
1. From the toolbar, select Start > Run.
2. Type cmd and press Enter.
3. Type ipconfig<space>/all and press Enter.
4. If the IP address and subnet mask are defined, record them:
IP address: ______________________________________
Subnet mask: ____________________________________
5. From the toolbar, select Start > Control
Panel > Network Connections.
From the toolbar, select Start > Settings
> Control Panel > Network and Dial-up
Connections.
6. Right-click Local Area Connection.
7. Select Properties.
8. Select Internet Protocol (TCP/IP).
9. Click Properties.
10. Select Use the following IP address.
11. In the IP Address field, type an IP address. If the patient monitor’s address begins
with 126, use 126.003.145.229.
If using a PC connected to the Unity Network MC network, the IP address on the
PC must match the institution’s Unity Network MC network domain. The network
domain is defined by the first numbers used in the IP address and subnet mask. If
the patient monitor’s address does NOT begin with 126, contact the IT department
for an IP address.
If using a PC connected to a patient monitor, and the IP address does not begin
with 126, change the PC IP address to match the first 3 digits of the patient
monitor’s address. The remaining address must be unique.
12. In the Subnet mask field, type 255.0.0.0.
13. In the Default gateway field, type 126.003.145.229 and click OK.
14. If prompted to restart the PC, select No.
15. From the toolbar, select Start > Control
Panel.
From the toolbar, select Start > Settings
> Control Panel.
16. Double-click System and select the
Computer Name tab.
Double-click System and select the
Network Identification tab.
17. Record the full computer name: __________________________________________
18. Close all open windows.
19. Restart the PC.
20. Continue with the instructions, “Disable firewall or networking services” on page 30.
To Next Page
Loading...
