6-16 Solar 8000M/i patient monitor 2026265-075C
Configuration: Advanced user procedures
If using a Class C address then all monitors that need to communicate
with each other must have the same first three octets. For example:
Calculate internet address
To generate an internet address from an Ethernet address, GE simply
converts the last three bytes of the Ethernet address from hex to decimal.
This combines the unique identifier along with the network ID to
produce the entire internet address.
Calculate the factory-assigned internet (IP) address as follows.
1. Write down the LAST SIX digits of the 12-digit monitor Ethernet
address. (The Ethernet address displays in the Boot Code banner
information.) An example is given below.
2. Consider the six digits as three separate hexadecimal pairs. Convert
each hexadecimal pair separately to a decimal number. All internet
addresses must be in decimal.
3. The first number of the internet address is always 126 (decimal). The
low three hex pairs of the IP address are the low three Ethernet
address hex pairs converted to decimal.
Enter internet address
Use the monitor SERVICE MODE menu in Main Code.
1. Access the SET INTERNET ADDRESS option starting from the
MAIN menu. Select MORE MENUS > MONITOR SETUP >
SERVICE MODE.
2. Enter password using the TRIM KNOB control to select the day and
month from monitor screen with leading zeros (e.g., July 4 = 0407).
3. Select MONITOR SETTINGS-> SET INTERNET ADDRESS.
4. Use the TRIM KNOB control to enter the correct digits.
5. Press the TRIM KNOB control to exit.
Power cycle
Power cycle the monitor by turning the rear power switch off and then
on. This configures the monitor with the new programmed data.
192.1.2.1 OK
192.1.2.2 OK
192.1.2.3 OK
192.2.2.4 won’t see other beds
00 : 00 : 7E : 26 : 13 : FD
126 . 38 . 19 . 253
To Next Page
Loading...
