2026265-075C Solar 8000M/i patient monitor 3-3
Installation: Back panel connections
CAUTION
Equipment damage. Connect all peripheral equipment
before plugging the power cord into an AC outlet.
Otherwise, connectors may be damaged.
TRAM-NET
TRAM-NET provides the network for communication with bedside
peripherals and acquisition modules.
NOTE
If two Tram-racs are connected in any configuration, one must have a
power supply.
The following devices connect to either of the two TRAM-NET ports on
the Solar 8000M/i monitor. The connector is a 9-pin, D-type.
Tram-rac 4a housing with or without power supply
Tram-rac 2 housing
Tram-rac 4 housing with or without power supply
Tram-rac 3 housing with or without power supply
Patient Data Module (PDM) connects to TRAM-NET 2/ePort
connector only.
Tram-rac 4a housing
Tram-rac 2 housing
009C
011A
To Next Page
Loading...
