GE Solar 8000M/i - Set Unit Name; Set Bed Number

2026265-075C Solar 8000M/i patient monitor 6-3
Configuration: Configuring a patient monitor
Set unit name
Up to seven characters are used to identify the care unit. These
characters display at the top right of the screen immediately preceding
the bed number.
Access SET UNIT NAME option, starting from the MAIN menu.
1. Select MORE MENUS > MONITOR SETUP > SERVICE MODE.
2. Enter password using the TRIM KNOB control to select the day and
month from monitor screen with leading zeros (e.g., July 4 = 0407).
3. Select MONITOR SETTINGS > SET UNIT NAME.
4. Use the TRIM KNOB control to select and change each character.
Up to seven characters may be entered.
5. Select SET UNIT NAME and press the TRIM KNOB control to exit.
Set bed number
The bed number identifies a particular patient bed. Up to five characters
are used to identify bed number. This number displays at the top right of
the screen.
Access SET BED NUMBER option, starting from the MAIN menu.
1. Select MORE MENUS > MONITOR SETUP > SERVICE MODE.
2. Enter password using the TRIM KNOB control to select the day and
month from monitor screen with leading zeros (e.g., July 4 = 0407).
3. Select MONITOR SETTINGS > SET BED NUMBER.
4. Use the TRIM KNOB control to select and change each character.
Up to five characters may be entered.
5. Select SET BED NUMBER and press the TRIM KNOB control to
exit.
↓ ↑
051A
↓ ↑
052A