5-4 Solar 8000M/i patient monitor 2026265-075C
Troubleshooting: Service menus
Service menus
The Boot Code Service Menu and Main Code SERVICE MODE menu
are generally used by qualified field engineers and factory service
personnel to troubleshoot, repair, or download new software to the
patient monitor.
WARNING
The Boot Code service menu or SERVICE MODE menu
is intended for qualified personnel only. It is possible to
lose patient data, damage the operating software for this
monitor, and even affect the Unity Network. Do not
‘experiment’ with any commands found in the service
menus.
Boot code Service Menu
Use the Boot Code service menu when downloading new Boot Code or
Main Code software to the patient monitor or when the patient monitor
exhibits a serious failure. Activate the Boot Code program as follows:
1. Hold down NBP Go/Stop and Zero All on the keypad or remote
control.
2. Press and release the TRIM KNOB control.
3. Keep holding NBP Go/Stop and Zero All until the Boot Code
information appears on the display.
Set up first Ethernet Port
This menu selection allows changes to the Ethernet address, gateway
address, and internet mask.
WARNING
Duplication of an Ethernet address on a network causes
data loss and possible Unity Network problems. If you
change the factory assigned Ethernet address, you must
record all other Ethernet addresses used on your network
to avoid duplication.
Set up second Ethernet Port
Same as Set up first Ethernet Port.
To Next Page
Loading...
