August 2008
5-4 Data Logging
The New Option The New option enables you to set up the parameters for creation of a
new log. To do so, proceed as follows:
1. Perform one of the following procedures:
• In the Log Manager>File menu (see Figure 5-3 on the previous
page), scroll to the New option and press [ENTER]. Or,
• In the Logging menu (see Figure 5-1 on page 5-1), scroll to the
New Log option and press [ENTER].
2. When the Create New Log windows opens (see Figure 5-4 below),
start entering a name for the log by using the four arrow keys to
scroll to the desired character and pressing
[ENTER].
Figure 5-4: The Create New Log Window
3. Repeat the above procedure until you have completed the log
name.
Note: At any time, you may press
[F1] (Delete) to remove the last
character entered.
4. When you have finished, press [F3] (OK) to accept the name, or
press [F2] (Cancel) to leave the window without creating a new log.
If you pressed [F3] above, the General tab of the log configuration
window opens (see Figure 5-5 on the next page). Continue on the next
page to enter the parameters for the new log.
6 7 8 9 - _ @ #
Delete
Cancel
OK
A B C D E F G H
I J K L M N O P
Q R S T U V W X
Y Z 0 1 2 3 4 5
Create New Log
& ( )
To Next Page
Loading...
