Data Logging 5-5
August 2008
The New Option (cont.) Note: The Log Name shown in the window is the one you entered on
the previous page.
Figure 5-5: The General Log Format Window
1. Scroll to the Format option and use the [
W] and [X] keys to select
either a Linear log or a Circular log. Press [ENTER] to confirm your
selection.
2. Scroll to the Type option and use the [W] and [X] keys to select
either a Standard log or an Error log. Press [ENTER] to confirm
your selection.
3. Scroll to the Start Date/Time option and press [ENTER]. Use the
[W] and [X] keys to highlight each date/time number and enter
the desired value. Press [ENTER] to confirm each value.
Note: You may change a value either by entering the new value with
the numeric keys or by using the [T] or [S] arrow keys to
scroll to the desired number.
4. Scroll to the End Date/Time option and press [ENTER]. Use the [W]
and [X] keys to highlight each date/time number and enter the
desired value. Press [ENTER] to confirm each value.
5. Scroll to the Logging Interval option and press [ENTER]. Use the
numeric keys to enter the desired logging interval (in seconds),
and press [ENTER] to confirm your entry.
The final step is to specify the parameters to be logged. To do this,
proceed to the next page.
General
Measurements
Cancel Activate
Log Name
10SEC.LOG
End Date/Time
Standard
Error
Linear
Circular
Type
Format
Logging Interval
Start Date/Time 01:38:08
2000/11/01
10
09:38:08
secs
2000/11/01
To Next Page
Loading...
