Data Logging 5-11
August 2008
The Start Option Use the Start option to restart a log that has been paused:
1. In the Log Manager window (see Figure 5-2 on page 5-2), use the
[T] and [S] arrow keys to highlight the log you wish to start.
2. At the Log Manager window, press [MENU] and then [ENTER].
3. Press the [X] key to highlight the Log menu and press [ENTER].
4. In the Log menu, scroll to the Start option and press [ENTER].
The PT878 returns to the Log Manager window, which now shows
the highlighted log as Pending or Running in the status line.
The End Option Use the End option to permanently stop a log that is currently pending
or running:
IMPORTANT: You cannot restart a log that you end. You must create
a new log with the same parameters.
1. In the Log Manager window (see Figure 5-2 on page 5-2), use the
[
T] and [S] arrow keys to highlight the log you wish to stop.
2. At the Log Manager window, press [MENU] and then [ENTER].
3. Press the [X] key to highlight the Log menu and press [ENTER].
4. In the Log menu, scroll to the End option and press [ENTER].
The PT878 returns to the Log Manager window, which now shows
the highlighted log as Finished in the status line. Any memory
allocated to the finished log is now available for use by other logs.
The Pause All Logs Option Use the Pause All Logs option to temporarily stop all logs that are
currently pending or running:
1. At the Log Manager window (see Figure 5-2 on page 5-2), press
[MENU] and then [ENTER].
2. Press the [X] key to highlight the Log menu and press [ENTER].
3. In the Log menu, scroll to the Pause All Logs option and press
[ENTER].
The PT878 returns to the Log Manager window, which now shows all
active logs as Paused in their status line.
To Next Page
Loading...
