Measurement and Analysis
296 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Figure 7-27: Selected anchor point on the inner border trace
Press the Process soft-button when ready.
Note: Data processing is configured by default to start
automatically if the cursor is not moved for a few seconds. If the
trace needs to be adjusted make sure to make the changes
immediately after
the ROI is displayed.
1. Place the trackball cursor over the desired point.
2. Selected point is marked by a red circle.
3. Click over the red circle, it will turn to a square.
4. Move the square to re-align the border trace
To Next Page
Loading...
