Measurement and Analysis
Vivid S5/Vivid S6 User Manual 341
R2424458-100 Rev. 2
To define a Normal value
Figure 7-48: Adding Normal value
1. Press CONFIG and select the Config category
Measure/Text.
The Measurement menu sheet is displayed (Figure 7-48).
2. In the Measurement menu, browse to the measurement of
interest.
The parameters for the selected measurements are
displayed in the Measurement menu sheet.
Note: to change Measurement category, press the
Heading in the Measurement menu and select another
Measurement category.
3. Select in the Normal value column.
The Normal value window is displayed.
1. Measurement category
2. Selected measurement
3. Parameters
4. Press to define Normal value
To Next Page
Loading...
