342
9. Auxiliary Console Removal/Installation
(1) For MT vehicle, remove transmission control knob.
(2) Using the screwdriver wrapped with the vinyl tape,
remove the tray.
(3) Using the screwdriver wrapped with the vinyl tape,
remove shift boot frame. Disconnect ignition switch.
(4) Remove the bolt, screw.
(5) The installation is in the reverse order of the removal.
10.The auxiliary Console Removal/Installation
(1) Remove in the order listed below.
(2) The installation is in the reverse order of the removal.
1
2
3
4
5
6
7
8
9
10
11
12
1 Auxiliary console left front end
2 Shift boot frame
3 Shift boot end shield
4Tray
5 Auxiliary console front part
6 Auxiliary console outer end shield upper plate
7 Auxiliary console outer end shield
8 Auxiliary console inner end shield
9 Auxiliary console compartment
10 Auxiliary console rear end shield
11 Rear ash tray
12 Auxiliary console rear part