Introduction 3
○○○○○○○○○○○○○○○○○○○○○○○
Important preliminary notes
Observe these important preliminary notes before getting into your instrument
AVOID PLACING DISKS ON TOP OF THE SPEAKERS
Do not place floppy disks on top of speakers, near magnets, telephones, or other sources of
electromagnetic fields. The disk contents could be damaged.
HOW TO UPDATE YOUR INSTRUMENT
To implement new functions in your instrument, you can update your instrument as de-
scribed below.
1. Before turning on the WK2, insert the floppy disk containing the latest release of the
Generalmusic Operating System.
2. Turn on the instrument. The message “Load OS?” appears in the display.
3. Press ENTER to confirm (pressing ESCAPE cancels the operation).
4. After pressing ENTER, the display shows the message “Loading!”.
5. When the operation is complete, WK2 is ready to play.
NB. To check the date of the Operating System, select the last page of the MIDI/GENERAL
functions.
SYSTEM RESET
To restore the instrument’s factory set status (default settings), proceed as described be-
low:
• Simultaneously press and hold the UPPER 1 selector button (located to the right of the
display) together with the PADS buttons 2, 3 and 4. The display shows the message
“SysRESET” for a few seconds the sets ready for playing.
WARNING
The Reset operation irremediably cancels all user-programmed data contained in the in-
strument’s RAM.
RECHARGEABLE, BACK-UP BATTERY
The WK2 is fitted with a Ni-Cd rechargeable battery to retain data while the instrument is off.
The battery is recharged while the instrument is turned on (not just plugged in !). When the
instrument is turned off, data is conserved in memory for appriximately 30 days. If the
battery discharges after not using the instrument for a long period of time, leave the instru-
ment on for at least 8/10 hours to recharge it completely.
To Next Page
Loading...
Need help?
General
