○○○○○○○○○○○○○○○○○○○○○○○
Midi/General 83
- ChnLock: (ON/OFF) the CHANNEL LOCK parameters locks the MIDI channel
configuration of the current Performance for the entire instrument, overriding the
individual settings of all the other Performances. To use this function, first set the
ChnLock parameter to ON, then modify the MIDI channels. Using this method the
programmed setting remains intact and applies to the entire instrument. Use the
DIAL to toggle between ON and OFF.
If you want the instrument to power up with a ChannelLock setting, store the
ChannelLock setting to the first Performance.
- Dump: the DUMP function transmits all the data contained in the internal memory
of via MIDI to an external MIDI device. This is a second possibility of safeguarding
your programmed data.
For a detailed explanation of the MIDI Dump procedure, turn to the next page.
- InitALL: this parameter allows you to initialize your WK2 in order to restore the
default (factory-set) conditions.
You can also restore a portion of the original memory by initializing the
Performances (PFM), the Sequencer (SEQ), or the Samples (SMP).
Rotate the DIAL to select the element that requires initialising, the press
ENTER twice to complete the procedure.
- rEL XX_XX_XX (DATE): This function (Release date) corresponds to the last page
of the MIDI/GENERAL section. Selecting this page shows the release date of the
last loaded WK2 operating system.
- Press ESCAPE to exit the current mode.
To Next Page
Loading...
Need help?
General
