Only for the audio-supporting models, adjust the audio output
volume on the PC.
Only for audio-supporting models, enable or disable
microphone.
Only for audio-supporting models, adjust the microphone
volume on the PC during audio communication between the PC
and the camera.
Take a snapshot of the current image displayed on the PC.
Start or stop local recording.
Only for two-way-audio-supporting models, start or stop
two-way audio.
Enable or disable digital zoom. – See 2.2.1 Digital
Zoom.
Only for face-snapshot-supporting models, start or
stop face snapshot.
By activating this function, the camera takes face snapshots, and
displays them on the right of the live view window. Before
activating this function, you must enable Face Detection - See
3.6.1.7 Face Detection.
Display in full screen mode.
Only for models with motorized varifocal lens, hide or show the
camera’s optical zoom and focus functions.
Reset the packet loss rate to zero.
Click to always display packet loss rate and bit rate information at
the bottom. Click again to restore to only displaying the
information for 3 seconds when the mouse cursor is moved onto
the live view.
Note:
1. The paths for saving snapshots and local recordings are set in Local Settings. See
3.1.2 Local Parameters.
2. The No. 17 and 18 buttons will appear on the floating toolbar when you move the
mouse cursor onto the live view.
To Next Page
