GF CMD - Page 66

66
User manual
Turn the probe to high or low depth range according to the choice above,
place it on the calibration point and start calibration by pushing “Yes” key. After
the measurement is finished (It takes approximately 1 min) the next screen is
shown.
The screen differs if you are calibrating CMD-Explorer / MiniExplorer,
which consists of three independent receivers:
Enter appropriate conductivities in mS/m. After that confirm whether you
wish to save the calibration by means of “Yes“ key.
Conductivity [mS/m]:
Shortest dip.: 10.0
Receiver 2: 10.0
Receiver 3: 10.0
C U
Conductivity [mS/m]:
Point 1 L: 10.0
C U
Move to calibration point 1!
Rotate probe to LOW DEPTH!
> Ok? Start measurement?
C U