Enter the x and y steps.
If you are going to measure in a grid of points (continuous area for 2D
mapping) enter the distance of measured lines (x-step) and points in lines (y-step).
If you are going to measure individual numbered lines only enter X-step=1 and
Y-step as the distance of individual points on the line (thus x will show the number
of line and Y the number of station then).
Measuring position
Go to the position shown in the right upper corner or change the given
position to the actual one. The arrows beside coordinates show the direction of the
measurement. It is possible to skip the point or to change the direction of
measurement as well. Then the measurement can start.
To Next Page
Loading...
Need help?
General
