24
Instruction manual
Electric Actuators Type EA15-250
4 Installation
If a complete valve is supplied, no mounting activities and adjustments are required. The actuator can directly be put into operation,
see Chapter “Commissioning” . When assembled by the customer, the actuator must be assembled, connected, and, if necessary,
adjusted.
4.1 Installing the actuator with valve
The actuators have a standard ISO 5211 interface, and can therefore be mounted on all valves that are provided with this interface
and the appropriate torques. The assembly using valves from GF Piping Systems with suitable coupling piece and adapter is possi-
ble in accordance with the following table:
EA15 EA25 EA45 EA120 EA250
2-way ball valve to DN50/2“
Ball valve type 546 Pro
X X
2-way ball valve to DN100/4“
Ball valve type 546 Pro
X X
3-way ball valve to DN50/2“
Ball valve type 543
X
Butterfly valves
Plastic type 567/578/565
Metal type 038/039
X X X
To Next Page
Loading...
Need help?
General
