EasyManuals Logo

GF EA25 User Manual

GF EA25
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
Instruction manual
Electric Actuators Type EA15-250
6.2 Adjusting end positions
The two end positions in the actuator have been factory set to 90°. A readjustment may be required after assembly by the customer
or after repair work.
The end positions can be set via the 4 buttons on the base board.
4 buttons
SET STORE CCW CW
Buttons
1. Open cover. To do so, loosen the 4 screws (torx size 20).
2. Connect the actuator to the appropriate power and let it rotate, until an end position is reached.
NOTE!
If an end position is not reached, the actuator automatically switches o after 2 min. and displays a fault message.
Adjusting end positions
Step Press button Position indicator
Repeat for every position
1.
SET* >3 s Blue flashing
2.
SET* Until color Blue/Red=OPEN Bau
Blue/Green=CLOSED
Blue/White=MIDDLE*
3.
CW
CCW
Until end position
CW
CCW
4.
STORE Briefly Position color
5.
Check position indicator color
6.
Next position press SET within 10 sec.
*EA25-250
3. Repeat this process, until all positions are adjusted.
4. Reinstall the cover and fasten it with the 4 screws.

Table of Contents

Other manuals for GF EA25

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GF EA25 and is the answer not in the manual?

GF EA25 Specifications

General IconGeneral
BrandGF
ModelEA25
CategoryController
LanguageEnglish

Related product manuals