GFA DC 8010 - Page 10

6
Status displays during operation
Display
Description
Standby. A movement command or pressing a pushbutton exits the
standby mode.
Preset maintenance cycle counter has been reached.
See menu item
8.5/8.6.
Display does not light up. Indicates a short circuit or overload of the 24V
DC supply voltage.
Flashing: Door is opening.
Flashing: Door is closing.
Doorisstationarybetweentwonallimitpositions.
DoorisinnallimitpositionOPEN.
Door is in programmed intermediate open.
DoorisinnallimitpositionCLOSE.
Non-ashing:programmingdisabled.
Movement command display
The movement commands appear on the display when the
door control receives OPEN, CLOSE or STOP commands.
Display
Description
E.
Display alternates between E. and number:
1. 1
OPEN command received.
1.2
STOP command received.
1.3
CLOSE command received.